環境空氣甲烷的測定HJ 604-2017，室內空氣，焦爐煤氣，乙酸乙酯，醫療器械，環氧乙烷，氨水，氨氣，室內空氣TVOC，苯系物，三甲胺，二甲醚，MTBE，乙酸乙酯，甲縮醛，乙縮醛

環境空氣甲烷的測定HJ 604-2017
環境空氣甲烷的測定HJ 604-2017 詳細信息：

甲烷毛細管柱：

固定相：多孔層開口管分子篩柱或其他等效毛細管柱

規格：30m*0.53mm*25um

應用： 環境空氣 總烴、甲烷和非甲烷總烴的測定 直接進樣-氣相色譜法HJ 604-2017


HJ 604-2017 環境空氣 總烴、甲烷和非甲烷總烴的測定 直接進樣-氣相色譜法
1 適用范圍
      本標準規定了測定環境空氣中總烴、甲烷和非甲烷總烴的直接進樣-氣相色譜法。
      本標準適用于環境空氣中總烴、甲烷和非甲烷總烴的測定，也適用于污染源無組織排放監控點空氣中總烴、甲烷和非甲烷總烴的測定。

當進樣體積為1.0ml時，本標準測定總烴、甲烷的檢出限均為0.06mg/m3（以甲烷計）, 測定下限均為0.24 mg/m3（以甲烷計）；非甲烷總烴的檢出限為0.07mg/m3（以碳計），測定下限為0.28 mg/m3（以碳計）。

2 規范性引用文件
      本標準引用了下列文件或其中的條款。凡是不注日期的引用文件，其有效版本適用于本標準。
      HJ 194 環境空氣質量手工監測技術規范
      HJ 664 環境空氣質量監測點位布設技術規范（試行）
      HJ 732 固定污染源廢氣揮發性有機物的采樣氣袋法
      HJ/T 55 大氣污染物無組織排放監測技術導則

3 術語和定義

      下列術語和定義適用于本標準。

3. 1

      總烴 total hydrocarbons (THC)

指在本標準規定的測定條件下，在氣相色譜儀的氫火焰離子化檢測器上有響應的氣態有機化合物的總和。

3.2

      非甲烷總烴 nonmethane hydrocarbons (NMHC)

指在本標準規定的測定條件下，從總烴中扣除甲烷以后其他氣態有機化合物的總和（除非另有說明，結果以碳計）。

4 方法原理

將氣體樣品直接注入具氫火焰離子化檢測器的氣相色譜儀，分別在總烴柱和甲烷柱上測定總烴和甲烷的含量，兩者之差即為非甲烷總烴的含量。

環境空氣甲烷的測定HJ 604-2017  測試譜圖：




Determination of ambient air methane HJ 604-2017
Determination of ambient air methane HJ 604-2017 Details:

Methane capillary column:

Stationary phase: Porous layer open tube molecular sieve column or other equivalent capillary column

Specifications: 30m*0.53mm*25um

Application: Ambient Air Determination of Total Hydrocarbons, Methane and Non-Methane Total Hydrocarbons Direct Injection-Gas Chromatography HJ 604-2017


HJ 604-2017 Ambient Air Determination of Total Hydrocarbons, Methane and Non-Methane Total Hydrocarbons Direct Injection-Gas Chromatography
1 Scope of application
      This standard specifies the direct injection-gas chromatography method for the determination of total hydrocarbons, methane and non-methane total hydrocarbons in ambient air.
      This standard applies to the determination of total hydrocarbons, methane and non-methane total hydrocarbons in ambient air, and also applies to the determination of total hydrocarbons, methane and non-methane total hydrocarbons in the air at monitoring points of fugitive emissions from pollution sources.

When the injection volume is 1.0ml, the detection limit of this standard for the determination of total hydrocarbons and methane is 0.06 mg/m3 (calculated as methane), and the lower limit of detection is 0.24 mg/m3 (calculated as methane); non-methane total hydrocarbons The detection limit is 0.07 mg/m3 (calculated by carbon), and the lower limit of determination is 0.28 mg/m3 (calculated by carbon).

2 Normative references
      This standard refers to the following documents or clauses thereof. For undated references, the valid edition applies to this standard.
      HJ 194 Technical Specification for Manual Monitoring of Ambient Air Quality
      HJ 664 Technical Specifications for Layout of Ambient Air Quality Monitoring Points (Trial)
      HJ 732 Sampling air bag method for volatile organic compounds in waste gas from stationary pollution sources
      HJ/T 55 Technical guidelines for monitoring fugitive emissions of air pollutants

3 Terms and Definitions

      The following terms and definitions apply to this standard.

3.1

      total hydrocarbons (THC)

Refers to the sum of gaseous organic compounds that respond on the hydrogen flame ionization detector of a gas chromatograph under the measurement conditions specified in this standard.

3.2

      nonmethane hydrocarbons (NMHC)

Refers to the sum of other gaseous organic compounds after deducting methane from total hydrocarbons under the measurement conditions specified in this standard (unless otherwise stated, the results are in carbon terms).

4 Principles of the method

The gas sample was directly injected into a gas chromatograph with a hydrogen flame ionization detector, and the contents of total hydrocarbons and methane were measured on the total hydrocarbon column and the methane column, respectively, and the difference between the two was the content of non-methane total hydrocarbons.

Determination of ambient air methane HJ 604-2017 test spectrum: